README.md in resque_spec-0.6.5 vs README.md in resque_spec-0.6.6

@@ -1,10 +1,10 @@
 ResqueSpec
 ==========
 
-A simple RSpec and Cucumber matcher for Resque.enqueue and Resque.enqueue_at
-(from `ResqueScheduler`), loosely based on
+A simple RSpec and Cucumber matcher for Resque.enqueue and
+Resque.enqueue_at/enqueue_in (from `ResqueScheduler`), loosely based on
 [http://github.com/justinweiss/resque_unit](http://github.com/justinweiss/resque_unit).
 
 ResqueSpec will also fire Resque hooks if you are using them. See below.
 
 This should work with `Resque v1.15.0` and up and `RSpec v2.5.0` and up.
@@ -188,10 +188,10 @@
 The after enqueue hook is always called when you use `Resque#enqueue`.
 
 The `perform` hooks: before, around, after, and on failure are fired by
 ResqueSpec if you are using the `with_resque` helper or set `ResqueSpec.inline = true`.
 
-Important! `Resque#enqueue_at` does not fire the after enqueue hook (the job has not been queued yet!), but will fire the `perform` hooks if you are using `inline` mode.
+Important! `Resque#enqueue_at/enqueue_in` does not fire the after enqueue hook (the job has not been queued yet!), but will fire the `perform` hooks if you are using `inline` mode.
 
 Note on Patches/Pull Requests
 =============================
 
 * Fork the project.