target.yml in denko-0.13.1 vs target.yml in denko-0.13.2

@@ -1,3 +1,37 @@
+# name: rp2040
+# fqbn: rp2040:rp2040:rpipicow
+# port: /dev/cu.usbmodem14B01
+
+# name: mega
+# fqbn: arduino:avr:uno
+# ort: /dev/cu.usbmodem14B01
+
+# name: mega
+# fqbn: arduino:avr:mega
+# port: /dev/cu.usbmodem14C01
+
 name: mega
-fqbn: arduino:avr:uno
+fqbn: arduino:avr:leonardo
 port: /dev/cu.usbmodem14B01
+
+# name: esp32
+# fqbn: esp32:esp32:esp32doit-devkit-v1
+# port: /dev/cu.SLAB_USBtoUART
+
+# name: esp8266
+# fqbn: esp8266:esp8266:nodemcuv2
+# port: /dev/cu.SLAB_USBtoUART
+
+# name: sam3x
+# fqbn: arduino:sam:arduino_due_x
+# port: /dev/cu.usbmodem14C0
+
+# name: samd
+# fqbn: arduino:samd:arduino_zero_native
+# port: /dev/cu.usbmodem14C01
+
+# Native USB ESP32 shouldn't be used since this doesn't enable USB CDC on boot.
+
+# name: esp32
+# fqbn: esp32:esp32:lolin_s3
+# port: /dev/cu.usbmodem14C01