README.rdoc in authlogic_rpx-1.1.0 vs README.rdoc in authlogic_rpx-1.1.1

@@ -34,12 +34,12 @@
 
 Three gems are required: authlogic, rpx_now, and authlogic_rpx. Install these as appropriate to your environment and preferences.
 
 Currently tested versions:
 * authlogic 2.1.3,2.1.2,2.1.1
-* rpx_now 0.6.11,0.6.6
-* authlogic_rpx 1.1.0
+* rpx_now 0.6.12 (0.6.11,0.6.6 support is deprecated)
+* authlogic_rpx 1.1.1
 
 
 === 1. Direct gem installation
 
   sudo gem install authlogic
@@ -50,12 +50,12 @@
 === 2. Using Rails config.gems
 
 Include in config/environment.rb:
   
   config.gem 'authlogic', :version => '>= 2.1.3'
-  config.gem 'rpx_now', :version => '>= 0.6.11', :source => 'http://gemcutter.org'
-  config.gem 'authlogic_rpx', :version => '>= 1.1.0', :source => 'http://gemcutter.org'
+  config.gem 'rpx_now', :version => '>= 0.6.12', :source => 'http://gemcutter.org'
+  config.gem 'authlogic_rpx', :version => '>= 1.1.1', :source => 'http://gemcutter.org'
 
 Then to install, run from the command line:
 
   sudo rake gems:install
 
@@ -63,11 +63,11 @@
 === 3. Using .gems file (e.g for heroku.com deployments)
 
 Include in RAILS_ROOT/.gems:
   
   authlogic --version '>= 2.1.3'
-  rpx_now --version '>= 0.6.11' --source gemcutter.org
-  authlogic_rpx --version '>= 1.1.0' --source gemcutter.org
+  rpx_now --version '>= 0.6.12' --source gemcutter.org
+  authlogic_rpx --version '>= 1.1.1' --source gemcutter.org
 
 
 == About Authlogic_RPX
 
 Using Authlogic_RPX is very similar to using standard authlogic, with the addition of just a few configuration options. So if you already have a project setup with authlogic, adding RPX support will be trivial.
\ No newline at end of file