Contents

Setting up new Minilab hardware:
1) Get it out of the packaging.
2) Install the Minilab software (InstaCal, universal library are most important).
3) Plug in the Minilab
4) Fire up the InstaCal software. Configure the board:
   - Custom Serial No.  253
   - No. Of Channels    8 Single Ended
   - Trigger Source     DIO0
   This configuration should work with the config file I have in the minilab driver
   directories.
5) Wire up the minilab. Use the below wiring:

On top of the minilab:
CH0 IN  <--->  D/A OUT 1
CH1 IN  <--->  GND
CH2 IN  <--->  DIO0
CH4 IN  <--->  PC +5V
CH6 IN  <--->  D/A OUT 0
DIO0    <--->  DIO3
DIO1    <--->  PC +5V
DIO2    <--->  GND

On the external digital IO pins:
3  <---> 11
4  <---> 11
5  <---> 28
6  <---> 11
7  <---> 36
8  <---> 11
9  <---> 11
10 <---> 20
22 <---> 27
23 <---> 21
24 <---> 34
25 <---> 21
30 <---> 21

6) Getrdone.

Version data entries

2 entries across 2 versions & 1 rubygems

Version	Path
minilab-2.0.1-x86-mingw32	doc/minilab_systest_setup.txt
minilab-2.0.0-x86-mingw32	doc/minilab_systest_setup.txt